ATB With LC/ APC and LC/ APC Duplex Pigtail

SC/APC-LC/APC | Single Mode G657.A2 Duplex Patch Cord | 2.0×4.1mm

Please be free to buy our SC/APC-LC/APC | Single Mode G657.A2 Duplex Patch Cord | 2.0×4.1mm products with competitive price. The customized service and the quotation consultation are available.

Quality production Stages For SC/APC-LC/APC | Single Mode G657.A2 Duplex Patch Cord | 2.0×4.1mm

So what should be taken into consideration when choosing a ‘good’ SC/APC-LC/APC | Single Mode G657.A2 Duplex Patch Cord | 2.0×4.1mm? What are the features that one should look for that defines the quality of any connector or jumper assembly? In order to appreciate the significance of a standard compliant product, one must first understand the process of actually making an optical connector assembly and the potential problems that could occur at each of the stages.

There are three main processes in the termination of a jumper Patch Cable, Preparation, Termination and Polishing and a total of 15 steps where negligence at any one of the steps will result in an inferior jumper assembly. Each process consists of small steps, and each step requires strict Quality Control of not only the equipment used, but also how each step is carried out.

preparation of fiber cable

1. Stripping of outer cable jacket
2. trimming of kevlar fibers to length
3. Stripping of 900um buffer
4. clean bare fiber
5. check fiber for damage
6. mix two part epoxy
7. degas epoxy
8. check ferule id

termination of fiber cable

1. inject epoxy and insert fiber
2. crimp kevlar to back post
3. crimp outer jacket
4. cure connector in oven

polishing of connector end face

1. cleave fiber
2. Remove excess epoxy by hand or machine
3. polish end-face by grinding machine